Fix for snapshot clone process in a stuck state
Site separation - preview results now respect transformation settings.
Snapshot Management - fixed empty status of the snapshot
Table component - "Reset table settings" didn't work - fixed
The toggle "Allow using telnet protocol" didn't work - fixed
Transceivers statistics table - delta column calculation fix
Arista EOS - /commands/arista/_eos/switchport - full cmd syntax used to prevent ambiguous command errors
Arista EOS - add support for another format output of the "show poe" command
Arista EOS - ARP in some cases was not parsed whole interface name for ARP record
Arista EOS - fixed false-positive error regarding VPN/VRF in "show ip interface" command
Arista EOS - fixed missing IP phones on some devices
Arista EOS - fixed parsing of "show interfaces vxlan 1" for interfaces with description
Arista EOS - fixed parsing of “show ip route” command in case VRF Leaks are in it
Arista EOS - fixed parsing of different output for command "show mlag detail"
Arista EOS - fixed parsing of different output for command "show ntp ass"
Arista EOS - Syslog - information is parsed from “show running-config” instead of “show logging”
Aruba CX - commands/arubacx/interface - fixed parsing for ip address / mask
Aruba switch - standardize port speed units with other vendors
Checkpoint Gaia - commands/checkpoint/_gaia/cluster/members/interfacesAll - fixed parsing for different command output
CheckPoint Gaia - fixed collecting of nested network / service groups in security policies
CheckPoint Gaia - fixed discovery on devices where the command "show management interface" is not available
CheckPoint Gaia - fixed parsing of different output for command "show cluster members interfaces all"
CheckPoint Gaia - fixed parsing of OSPF InterArea and External routes
CheckPoint Gaia (Security Management) - don’t download policy packages without configured installation target
Cisco - fix error created by calling ambiguous command (show interface switchport, show interface status err-disabled, show ip interface, show spanning-tree bpdu)
Cisco - fixed ambiguous command "sh mpl interf" by "show mpls interfaces"
Cisco - fixed parsing of commands “show mac address-table multicast“ and “show mac-address-table multicast“ for cases there are unexpected lines at the beginning of the output
Cisco - Fixed parsing of VRF Route-Targets in an IP format
Cisco - various platforms - suppress error messages when tunnel present on port.
Cisco ACI - fixed parsing of 'inherit' speed value from "show interface" command
Cisco ACI, NX-OS - fixed parsing of "show environment" command in case power supply’s column model is empty
Cisco HSRP - fixed preemption
Cisco IOS - add stacking support for catalyst 2960-s platform
Cisco IOS - commands/cisco/mcast/macMulticast - add parsing support for MAC table records with multiple interfaces per row
Cisco IOS - commands/cisco/mcast/pimNeighbor - fixed missing PIM version & different output structure on old IOS version
Cisco IOS - commands/cisco/vrrp - fixed parsing of preempt parameter
Cisco IOS - Fixed parsing for AAA section from running config.
Cisco IOS - fixed parsing of "show power inline" command for cases of empty device name
Cisco IOS - fixed parsing of ”show version” command in case of faulty master switch
Cisco IOS - Fixed parsing of command "sh ip mroute vrf <vrfName>" that would get translated by the DNS server
Cisco IOS - fixed parsing of command ”show ip igmp snooping groups” in case port list does not contain any interface for a group
Cisco IOS - fixed parsing of the different output for command "show ip flow export command"
Cisco IOS - fixed parsing of the different output format of command “show ip mroute count“
Cisco IOS - removed false positive error emitting in "show monitor detail" command
Cisco IOS - tasks/deviceConfig/current - allow empty configuration when device return it
Cisco IOS + IOS-XE - fixed false-positive error detection in command “show dot1x all details“ in case of Tacacs session expiration.
Cisco IOS cat9300 - commands/cisco/vxlan/nveVni - fixed parsing for new command output format
Cisco IOS-XE - added parsing of another format of "show env all" and "show env status"
Cisco IOS-XE - Fixed parsing of command “show interfaces transceiver detail“ for another output format
Cisco IOS-XE fixed parsing of "show environment all" command for devices with multiple PSU
Cisco IOS-XR - ACL add suport for networks in CIDR format
Cisco IOS-XR - fixed parsing for dot1x interfaces configured as authenticator and supplicant
Cisco IOS-XR - Removed backup (FRR) routes from routing tables.
Cisco IOS-XRv - fixed platform, model and uptime parsing
Cisco IOS/IOS-XE - fixed parsing of “CVTA phone port” and “Two-port Mac Relay“ CDP capabilities
Cisco ISA - commands/_osVersions/showVersion - fixed parsing of ISA platform
Cisco Meraki - API v0 input validation updated for endpoint switch-ports/get-device-switch-port-statuses
Cisco Meraki - commands/cisco/_meraki/v0/devices/switch/ports - Unexpected stp guard value: root guard.
Cisco Meraki - fixed parsing of Meraki device clients.
Cisco Nexus - commands/cisco/mac - Added support for FabricPath MAC entries
Cisco Nexus - commands/cisco/switchport - fix parsing for VLAN ID ranges that are split over multiple lines
Cisco Nexus - fixed parsing of ”show policy-map system type network-qos” command to support another output format
Cisco Nexus - "show environment fex all" cmd - added support of "absent" PSU parsing
Cisco Nexus - added parsing of another output format of "show logging server” command
Cisco Nexus - fixed parsing of FEX environment information
Cisco Nexus - fixed parsing of in/out bytes, multicasts and broadcasts from "show interface" command
Cisco Nexus - Fixed parsing of STP port status on STP broken ports.
Cisco Nexus, ACI - fixed Device Mode value for FEX devices in Technology/Platforms/Environment
Cisco nx9000-aci - commands/cisco/igmp/group - Group IP parsing fix
Cisco SG - commands/_osVersions/showVersion - Add OS discovery support for cisco Sg220.
Dell Powerconnect - added MTU and MAC for interfaces
Dell Powerconnect - fixed parsing of MAC address from “show interfaces“ command
Dell Powerconnect - fixed parsing of speed and duplex from “show interfaces status“ command to support also N/A and unknown values
Dell Powerconnect n1500 - Fixed parsing for the command "show spanning-tree detail".
Duplicate IP table - false-positive unnumbered IP removed
Extreme XOS - added support for another output format of "show sharing" command
Extreme XOS - “show ports transceiver information detail“ fixed parsing of -infinity value
Extreme XOS - fixed parsing of port names for "show stpd <stpdDomain> ports counters" command
Extreme Enterasys - tasks/portChannel - port state fix
Extreme XOS - Fixed parsing of command 'show ip-security dhcp-snooping vlan' to allow more or none ports in Trusted ports section
Extreme XOS - fixed parsing of command “show ports transceiver information detail“ to allow transceivers without any statistics
F5 - commands/f5/_big-ip/listNetSelf - add support of ipv6 addresses
F5 BigIP - fixed parsing of Cluster members if they dont have Failover Unicast configured.
Fortinet FortiGate - commands/fortinet/diagSysNtpStatus - fixed parsing if all configured servers are unresolved
Fortinet FortiGate - fixed parsing of "get system status" command for FortiGateRugged platform to allow IPF device discovery
Fortinet FortiGate - LLDP link wasn’t established for HA ports
Fortinet FortiGate - Routed port classification fix for L2 edges
HP Aruba - commands/_osVersions/showVersion - fixed parsing for Aruba Mobility Master and Mobility Controller.
HP Aruba - Mobility Master - platform and LLDP parsing fixed
HP Aruba 7200 - Fix parsing for APs that dont respond to "show ap debug system-status ap-name <apName> command".
HP Aruba CX - fixed memory parsing
HP Aruba CX - fixed parsing for "show vsx brief" with state in sync-primary
HP Aruba CX - fixed parsing of "show interface" command with different output structure
HP Aruba CX - fixed parsing of different output for command "show vsx status"
HP Aruba CX - fixed parsing of property LAST in command "show ntp association"
HP Aruba S3500-24P - commands/hp/_aruba/inventory - Fixed parsing of serial number for Aruba switch.
HP Aruba switch - added parsing of the different output format of ”show tech buffers” command
HP Aruba switch - fixed parsing of different output for command "show spanning-tree"
HP Aruba switch - fixed STP task mapping for RPVST for cases designated bridge ID is missing.
HP ArubaCX - fix parsing of "show ip ospf neighbor detail" command in case priority is missing
HP ArubaCX - fix parsing of command 'show ip ospf interface' for cases local IP address is missing
HP ArubaCX - fix parsing of command 'show ip ospf interface' from Aruba OS version 10.07 and higher
HP ArubaCX - fixed parsing of "show interface mgmt" in case mgmt interface is disabled
HP ArubaCX - fixed parsing of "show ip ospf interface all-vrfs" and "show ip ospf neighbor detail" to not change VRF name to lower case
HP ArubaCX - fixed uptime parsing (it isn't always provided)
HP Comware - added support for another output format of “display arp“ command
HP Comware - fixed parsing of "display fan" command for the different output format
HP Comware - fixed parsing of "display ip interface" command
HP Comware - fixed parsing of "display power" command for the different output format
HP Comware - fixed parsing of “display ospf interface verbose“ command to support multiple areas for process ID and removed false positive error emitting in case there is configured process without any area
HP Comware - fixed parsing of commands with large output (added cli clearing for Comware 3 format)
HP Comware - tasks/l2Interfaces - fixed mapping of interfaces in case trunk doesn't contain any permitted vlans
HP Comware 5130 - commands/hp/_comware/currentConfiguration - AAA scheme fixed parsing for test-profile in aaa server configuration
Juniper Junes - fixed parsing of different output for command "show configuration | display set”
Juniper Junos - added parsing for another output format of command “show lldp neighbor“
Juniper Junos - fixed false-positive error emitting in STP task for STP disabled interfaces
Juniper Junos - fixed mapping of stacking for cases switch is not present (disconnected)
Juniper Junos - fixed parsing of "show chassis environment" command to support different output format of fans
Juniper Junos - fixed parsing of "show route" command for discarded routes
Juniper Junos - fixed parsing of "show vrrp detail" command in case "version" is missing
Juniper Junos - Fixed parsing of LLDP neighbors.
Juniper Junos - fixed parsing of the routing table to parse correctly Administrative Distance and Metric
Juniper Junos - fixed parsing of secondary address for command "show interfaces statistics detail"
Juniper Junos - removed duplicates in the routing table
Mikrotik RB1100 - Fixed parsing for command "ip ipsec installed-sa print detail"
Mikrotik RouterOS - fixed parsing of IP addresses of actual-interface in command 'ip address print detail'
Palo Alto - fixed parsing of different output for command "show routing route"
Palo Alto, F5 clusters - Fix for establishing routing protocol edges
Paloalto - fixed parsing for the routing table.
PaloAlto 5200 - commands/paloalto/showConfigMerged - fix parsing, when vsys has no configuration
Pathlookup - STP edge between switch and firewall in a cluster with virtual mac fix
Routing table recursive lookup for VXLAN and other forwarding properties fix
STP topology fix for port role master
Versa VOS - Fixed BGP task mapping for cases total received Pfx is not available.
Versa VOS - fixed mapping of API endpoint "/vnms/dashboard/appliance/<appliance>/live?command=ospf/interface/int-extensive"
Wrong MAC address classification as a phone for proxy ARP fix.